Browsing by Author "Kielce University of Technology"
Now showing 1 - 7 of 7
- Results Per Page
- Sort Options
Item Analysis of phosphorus speciation in primary sludge in the annual cycle(Lviv Politechnic Publishing House, 2017-03-21) Bezak-Mazur, Elżbieta; Stoińska, Renata; Szeląg, Bartosz; Kielce University of TechnologyThe objective of the research was to investigate phosphorus speciation in sewage sludge in order to determine the amount of the element that can be assimilated by plants after the application of sludge for nature-related purposes. Since the possibility of using sludge for such purposes is of considerable importance, this paper analyses the content of different phosphorus speciation forms (including the bioavailable ones) in primary sludge. The studies’ results indicate that the maximum share of mobile forms (Ca-EDTA+Na- EDTA) in primary sludge in the annual cycle amounts to merely 46 %. This confirms the observation that in the examined period the hardly-available, organic phosphorus forms are dominant (fractions H2SO4 and NaOH). Therefore, after the application of primary sludge for nature-related purposes, only a small portion of phosphorus included therein is assimilated by plants.Item Angle of injection impact on the combustion process in a compression-ignition engine(Lublin, 2018-06-26) Łagowski, P.; Kurczyński, D.; Wcisło, G.; Pracuch, B.; Tomyuk, V.; Kielce University of Technology; Malopolskie Centre for Renewable Energy Sources "BioEnergia”; Lviv National Agrarian UniversityThe article presents the impact of hydrocarbon fuel angle of injection on heat emission characteristics in a compression – ignition AD3.152 engine. The angle of injection has a significant impact on the primary engine operating parameters and combustion process indicators, which include the proportion of combustion which occurs according to kinetic and diffusion models, heat emission rate and the combustion process duration. The characteristics describing emission of a relative heat quantity were determined on the basis of an analysis of actual, indicator diagrams averaged over 100 runs, under the assumption that the combustion process ends by the time the exhaust valve opens. During the test, the engine operated according to an external speed characteristic. Tests were carried out for three fuel angles of injection: 13, 17 and 21 crankshaft rotation degrees.Item Influence of Perkins 1104D-44TA motor powered with SME supply on the CO, NOx, THC and O2 emissions(Lublin, 2018-06-26) Wcisło, G.; Kurczyński, D.; Łagowski, P.; Pracuch, B.; Leśniak, A.; Tomyuk, V.; University of Agriculture in Krakow; Malopolskie Centre for Renewable Energy Sources "BioEnergia”; Kielce University of Technology; Lviv National Agrarian UniversityThe paper presents the results of research on the impact of Perkins 1104D-44TA engine powered with sunflower oil methyl esters and, for comparison, with diesel fuel, in terms of emission of CO, THC, NOx and O2. The tests were carried out on the engine test stand. During the tests, the engine worked according to the external speed characteristics in the range from 1000 to 2200 rpm. The esters used for powering the tested engine were produced using the GW 200 reactor designed and made by Grzegorz Wcisło, one of the co-authors of the paper. The results of the tests carried out showed a decrease in the concentration of carbon monoxide in the exhaust gases, hydrocarbons when powering the engine with sunflower oil esters in relation to powering the engine with diesel fuel. At the same time, the concentration of nitrogen oxides and oxygen in the exhaust gases increased. The reduction of THC and CO emissions is the result of better combustion and afterburning of fuel. However, the increase in the amount of oxygen in the exhaust gases results from the fact that in the biofuel structure there is oxygen which is used in combustion and reduces the oxygen demand from the atmosphere. On the other hand, the increase in NOx emissions is the result of a higher combustion temperature than when the engine is powered by diesel fuel.Item Influence of the SME run Perkins 1104D-44TA engine on the power and torque as well as unitary and hourly fuel consumption(Lublin, 2018-06-26) Łagowski, P.; Kurczyński, D.; Wcisło, G.; Pracuch, B.; Leśniak, A.; Tomyuk, V.; Kielce University of Technology; University of Agriculture in Krakow; Malopolskie Centre for Renewable Energy Sources “BioEnergia”; Cracow University of Economics; Lviv National Agrarian Universityhe article presents the results of tests determining the impact of using sunflower oil methyl esters on power and torque as well as unitary and hourly fuel consumption of the Perkins 1104D-44TA engine. Biofuels were produced in the Fuel and Energy Laboratory belonging to the Maopolskie Centrum Energii Odnawialnej (Małopolskie Center for Renewable Energy Sources), while analyzes of the selected fuel parameters were performed both in the above-mentioned laboratory and in the Liquid Biofuels Laboratory at the University of Agriculture in Krakow. Engine tests were carried out on the engine test stand at the Kielce University of Technology. During the tests, the engine worked according to the external speed characteristic. The results of the tests have shown that the engine supplied with the SME achieves slightly lower values of both power and torque than in the case of commercial fuel oil type Ekodiesel Ultra from the ORLEN S.A company. There was also an increase, especially in the case of higher unitary fuel consumption. Hourly fuel consumption was higher when supplied with SME in relation to the diesel fuel supply, although not as much as unitary consumption. The increase in SME consumption at the engine supply can be explained by the lower fuel value of SME, which contains oxygen in its structure.Item Креативні та координаторські якості в архітектурній освіті та на шляху професії до майбутнього(Видавництво Львівської політехніки, 2018-02-26) Камьонка, Луціан В.; Kamionka, Lucjan W.; Політехнічний університет міста Кельце; Kielce University of TechnologyДосліджено проблеми освіти у сфері архітектури та містобудування на рівні середньої школи у формі пілотної програми і в освіті інженерів архітектури на рівнях бакалавра та магістра. Створення та координація формування навколишнього середо- вища людей – основні риси освіти та професійної/творчої діяльності архітектора. Роль архітектора у цьому процесі надзвичайно важлива. Незалежно від того, чи архітектор творить у маленькій команді, чи працює у великій фірмі, складність творчого процесу, а також масштаб рішень роблять його відповідальним за творення простору і координацію процесу проектування. Тісна співпраця із промисловими дизайнерами та експертами з управління будівлями на кожному етапі розроблення –ключ до досягнення цілей. Будівельне проектування повинно бути результатом багатокрокового аналізу, кожне з рішень якого підтримується моделюванням, що дає змогу оцінити вплив прийнятої ідеї.Item Модель вибору сповіщувачів системи безпеки(Видавництво Львівської політехніки, 2023-02-28) Овсяк, В. К.; Турчак, В. Р.; Овсяк, О. В.; Ovsyak, V. K.; Turchak, V. R.; Ovsyak, O. V.; Українська академія друкарства; Кельцький технологічний університет; Національний лісотехнічний університет України; Ukrainian Academy of Printing; Kielce University of Technology; Ukrainian National Forestry UniversityВиявлено, що пошуковими системами забезпечується широкий вибір сповіщувачів з технічними характеристиками. Значний спектр характеристик забезпечує застосування сповіщувачів для розв'язання задач в системах безпеки. Розроблена модедь пошуку та сортуваання сповіщувачів систем безпеки. В її основу закладені необхідні та достатні характеристики сповіщувачів, які забезпечують їх вибір залежно від поставлених задач для систем безпеки. На підставі вимог користувача і технічних характеристик сповіщувачів формуються критерії їхнього відбору. Введено пріорітети критеріїв для вибору сповіщувачів систем безпеки. В моделі утворюється впорядкований список сповіщувачів, які відповідають заданим критеріям. Кожному сповіщувачу списку приписується неповторюваний індивідуальний номер. За важливістю критеріїв здійснюється ранжування сповіщувачів, кількість ітерацій якого залежить від кількості обраних критеріїв. Максимальна зміна позиції сповіщувача списку визначається як відношення кількості сповіщувачів списку до номера пріорітету критерію. Наведено приклад застосування розробленої моделі для вибору сповіщувачів систем безпеки. В першій ітерації ражування сповіщувачів відбувається залежно від типу поля першого критерію, яке може бути описове чи числове. Якщо поле із критерієм описове, то його вміст верифікується та сортуються сповіщувачі. В іншому випадку – ранжування по значенню параметра сповіщувача. Допустиме ранжування сповіщувачів – всі позиції таблиці. За всіма інщими критеріями максимальна зміна позицій сповіщувачів залежить, як від значення критерію так і пріорітету критерію, який обмежує максимальну зміну позицій. В подальшому дослідженні пропонується альтернатива ранжування за критеріями, але не за відношеннями критеріїв, а за вибором користувача.Item Традиція та контекст в освіті майбутніх архітекторів(Видавництво Львівської політехніки, 2018-02-26) Гіль-Масталерчик, Й.; Gil-Mastalerczyk, J.; Політехнічний університет міста Кельце; Kielce University of TechnologyДосліджено питання, які стосуються формування архітектурних об’єктів у міських просторахі у природних просторах, де оточення – контекст – відносини із природою і збудованим середовищем створюють важливий функціональний і просторовий зв’язок.