Cheylyakh, Yan2019-02-112019-02-112018-01-292018-01-29Cheylyakh Y. Regulation of the phase-structural composition and metastability of austenite by alloying elements and parameters of tempering for increase wear-resistance of Fe-Cr-Mn deposited steel / Yan Cheylyakh // Ukrainian Journal of Mechanical Engineering and Materials Science. — Lviv : Lviv Politechnic Publishing House, 2018. — Vol 4. — No 1. — P. 1–11.https://ena.lpnu.ua/handle/ntb/44114It is shown that under the influence of alloying (Cr, Mn, C, Si, Ti, N, V) during electric arc hardfacing with a flux cored wire, as well as technological tempering parameters at temperatures of 300–700 °C, the phase-structural composition of the cost-saving alloyed deposited steel (from 0 to 75 % quenching martensite and austenite), the degree of metastability of austenite are regulated. At optimal parameters of alloying and tempering, an increased wear resistance is achieved due to the development of the deformation induced martensite γ→α' transformation of austenite during the wear process, which causes the effect of self-strengthening during testing and operation. This is an important advantage of the developed metastable deposited steel before the deformation-stable metal.1-11endeposited steelalloyingmetastable austenitemartensitetemperingwear resistanceArticle© Національний університет „Львівська політехніка“, 2018© Cheylyakh Y., 201811Cheylyakh Y. Regulation of the phase-structural composition and metastability of austenite by alloying elements and parameters of tempering for increase wear-resistance of Fe-Cr-Mn deposited steel / Yan Cheylyakh // Ukrainian Journal of Mechanical Engineering and Materials Science. — Lviv : Lviv Politechnic Publishing House, 2018. — Vol 4. — No 1. — P. 1–11.