Ukrainian Journal of Mechanical Engineering and Materials Science. – 2021. – Vol. 7, No. 1/2

Permanent URI for this collectionhttps://ena.lpnu.ua/handle/ntb/57215

Науковий журнал

Засновник і видавець Національний університет «Львівська політехніка». Виходить двічі на рік з 2015 року.

Ukrainian Journal of Mechanical Engineering and Materials Science = Український журнал із машинобудування і матеріалознавства : науковий журнал / Lviv Politechnic National University ; editor-in-chief Oleksiy Lanets . – Lviv : Lviv Politechnic Publishing House, 2021. – Volume 7, number 1/2. – 62 p.

Browse

Filters

20211

Settings

Has files: YesSubject: search.filters.subject.fused deposition modeling, 3D printing, infill pattern, tensile strength, PLA

Search Results

Now showing 1 - 1 of 1
  • Thumbnail Image
    Item
    The effects of infill patterns on the mechanical properties of 3D printed PLA parts fabricated by FDM
    (Lviv Politechnic Publishing House, 2021) Eryildiz , Meltem; Faculty of Engineering and Architecture, Beykent University
    The purpose of this study is to analyze the effect of the infill pattern on the mechanical properties of 3D printed PLA parts. Polylactic acid (PLA) parts were fabricated by fused deposition modeling (FDM) at various infill patterns at 30 % infill density. Five different infill patterns (stars, 3D honeycomb, honeycomb, gyroid, Hilbert curve) have been investigated. The results have shown that the honeycomb infill pattern exhibited the highest mechanical properties with 29.43 MPa and 2.04 mm elongation due to the improved strength of the strut junctions in this pattern. In the case of the Hilbert curve pattern, compared to the other patterns, though they have the same infill density, tensile strength was lowest because of the presence of large air gaps in the pattern that induced rapid fracture during the test. The optical microscope images of the fracture surfaces were compatible with the tensile strength results. Also considering the build time and the spent filament, it can be said that the honeycomb infill pattern is very promising. Lastly, the results showed that the tensile strength and elongation of 3D printed PLA parts increased 43.4 % and 32 %, respectively, under optimum infill pattern conditions. The findings of this study will help manufacturing firms and researchers to decide on the appropriate infill pattern, so that FDM parts can be fabricated with minimal production cost and good mechanical properties.