Вісники та науково-технічні збірники, журнали

Permanent URI for this communityhttps://ena.lpnu.ua/handle/ntb/12

Browse

Author: search.filters.author.Tomyuk, V.Subject: search.filters.subject.combustion engine

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Influence of Perkins 1104D-44TA motor powered with SME supply on the CO, NOx, THC and O2 emissions
    (Lublin, 2018-06-26) Wcisło, G.; Kurczyński, D.; Łagowski, P.; Pracuch, B.; Leśniak, A.; Tomyuk, V.; University of Agriculture in Krakow; Malopolskie Centre for Renewable Energy Sources "BioEnergia”; Kielce University of Technology; Lviv National Agrarian University
    The paper presents the results of research on the impact of Perkins 1104D-44TA engine powered with sunflower oil methyl esters and, for comparison, with diesel fuel, in terms of emission of CO, THC, NOx and O2. The tests were carried out on the engine test stand. During the tests, the engine worked according to the external speed characteristics in the range from 1000 to 2200 rpm. The esters used for powering the tested engine were produced using the GW 200 reactor designed and made by Grzegorz Wcisło, one of the co-authors of the paper. The results of the tests carried out showed a decrease in the concentration of carbon monoxide in the exhaust gases, hydrocarbons when powering the engine with sunflower oil esters in relation to powering the engine with diesel fuel. At the same time, the concentration of nitrogen oxides and oxygen in the exhaust gases increased. The reduction of THC and CO emissions is the result of better combustion and afterburning of fuel. However, the increase in the amount of oxygen in the exhaust gases results from the fact that in the biofuel structure there is oxygen which is used in combustion and reduces the oxygen demand from the atmosphere. On the other hand, the increase in NOx emissions is the result of a higher combustion temperature than when the engine is powered by diesel fuel.
  • Thumbnail Image
    Item
    Influence of the SME run Perkins 1104D-44TA engine on the power and torque as well as unitary and hourly fuel consumption
    (Lublin, 2018-06-26) Łagowski, P.; Kurczyński, D.; Wcisło, G.; Pracuch, B.; Leśniak, A.; Tomyuk, V.; Kielce University of Technology; University of Agriculture in Krakow; Malopolskie Centre for Renewable Energy Sources “BioEnergia”; Cracow University of Economics; Lviv National Agrarian University
    he article presents the results of tests determining the impact of using sunflower oil methyl esters on power and torque as well as unitary and hourly fuel consumption of the Perkins 1104D-44TA engine. Biofuels were produced in the Fuel and Energy Laboratory belonging to the Maopolskie Centrum Energii Odnawialnej (Małopolskie Center for Renewable Energy Sources), while analyzes of the selected fuel parameters were performed both in the above-mentioned laboratory and in the Liquid Biofuels Laboratory at the University of Agriculture in Krakow. Engine tests were carried out on the engine test stand at the Kielce University of Technology. During the tests, the engine worked according to the external speed characteristic. The results of the tests have shown that the engine supplied with the SME achieves slightly lower values of both power and torque than in the case of commercial fuel oil type Ekodiesel Ultra from the ORLEN S.A company. There was also an increase, especially in the case of higher unitary fuel consumption. Hourly fuel consumption was higher when supplied with SME in relation to the diesel fuel supply, although not as much as unitary consumption. The increase in SME consumption at the engine supply can be explained by the lower fuel value of SME, which contains oxygen in its structure.