Вісники та науково-технічні збірники, журнали

Permanent URI for this communityhttps://ena.lpnu.ua/handle/ntb/12

Browse

Search Results

Now showing 1 - 3 of 3
  • Thumbnail Image
    Item
    Акустичний газоаналізатор
    (Видавництво Львівської політехніки, 2018-02-26) Рак, В. С.; Луцик, Я. Т.; Національний університет «Львівська політехніка»
    Запропоновано метод вимірювання відносних концентрацій складових дво- та трикомпонентних сумішей газів, оснований на залежності швидкості поширення звуку від таких параметрів, як молярна маса газів у суміші, їх відносна концентрація, теплоємність за сталого тиску, теплоємність за сталого об’єму та абсолютна температура. Для підвищення точності запропоновано перейти від вимірювань швидкості до вимірювань частоти. Показано, що за сталої довжини хвилі частота акустичного резонатора лінійно зростатиме відповідно до зміни швидкісті поширення звуку в газовій суміші. Запропоновано та перевірено алгоритм програми визначення концентрацій дво- та трикомпонентних сумішей газів за резонансною частотою. Обґрунтовано, що основними чинниками, що впливають на точність вимірювань, є шуми автогенератора та добротність акустичного резонатора. Запропоновано математичну модель і доведено, що акустичні газоаналізатори порівняно простої конструкції можуть забезпечувати прийнятну точність.
  • Thumbnail Image
    Item
    Designing multi-sensory system for monitoring gas
    (Видавництво Львівської політехніки, 2014) Marikutsa, U.; Narushynska, O.
    This article is devoted to the design of a system to detect gases. The paper describes a system that is based on the controller STM32F4 and includes a series of sensors MQ. System requirements were formulated, the software was developed. Здійснено проектування системи для виявлення газів. Система побудована на базі контролера STM32F4 та включає сенсори серії MQ. Сформульовано вимоги до системи та розроблено програмне забезпечення.
  • Thumbnail Image
    Item
    Дослідження граничнодопустимих режимів роботи теплових чутливих елементів для газоаналітичних пристроїв
    (Видавництво Львівської політехніки, 2014) Макар, О. В.
    Досліджуються режими роботи теплового чутливого елемента за постійних значень теплофізичних параметрів газової суміші. За цих самих режимів забезпечується висока відтворюваність результатів вимірювання, висока чутливість і не перевищується допустима температура чутливого елемента. Combined methods of analysis based on the measurement of thermal and mechanical parameters of the gaseous mixture could be applicable in the development of gas analyzers for energy-saving technologies and new technologies of the enhanced raw materials and waste processing. Gas analyzers developed with the application of such methods of measurement have more advanced metrological and operational characteristics under complex measuring conditions and are not susceptible of the effect of corrosive contaminants and acidic gases.Thermal sensors, acting as transducers of thermal-physical and mechanical parameters of the gaseous mixture into an electrical signal, produce the output, the change of electrical resistance, which depends upon the thermal conductivity, heat capacity, energy consumption, density and viscosity of the gaseous mixture. The detection of the optimum operational modes of a heat sensing element, which could be heated up by the current, is essential for the pilot research of new circuit solutions in gas analyzing technologies. With certain restrictions, preconditioned by the small ratio of the length of the sensing element to its diameter, it would be reasonable to investigate the change of the measuring element sensitivity under the conditions of the current change, the change in the gaseous mixture expenditure and the temperature of the sensing element. The mathematical model of the measuring element with the heat sensing element is studied in this paper, obtained as a result of experimental calculations for the purpose of detecting the parameter values.