Вісники та науково-технічні збірники, журнали
Permanent URI for this communityhttps://ena.lpnu.ua/handle/ntb/12
Browse
3 results
Search Results
Item Vibration impact and noise protection devices with DVA for wheeled vehicles(Видавництво Львівської політехніки, 2020-09-14) Diveev, Bogdan; Lviv Polytechnic National UniversityThe article investigates vibration and noise protection devices for wheeled vehicles using dynamic vibration absorbers (DVA). Algorithms for modeling their dynamic characteristics based on adaptive calculation schemes are presented. A non-linear suspension with DVA and a noise-absorbing partition is considered, which is due to the introduction of a layered composite thinwalled structure with an intermediate damping layer with high damping properties and a DVA system, which provides better vibration and noise absorption. The problems of shock propagation during the overturn of the bus to passengers are also considered. The influence of the parameters of the shock absorber on the dynamic properties of the bus is investigated. The optimal parameters of the shock absorber are determined.Item Semi-active vibration absorbers for the high-rise objects(Lviv Politechnic Publishing House, 2018-01-29) Diveyev, Bohdan; Lviv Polytechnic National UniversityTo determine the optimal parameters of the dynamic vibration absorber (DVA), a complete multi-parameter model of the dynamics of machines and structures is required. A model with two degrees of freedom is unacceptable for a sufficiently precise calculation with sufficient accuracy of the oscillations of the design, and thus for an adequate description of its dynamic characteristics. Therefore, in practice, it is necessary to investigate the design using a complex model. In particular, the methods for determining the concentration of mass and stiffness can be used on the basis of a refined theoretical calculation. A number of numerical schemes (NS) are known for complex vibro-loaded structures, in which developed methods of decomposition and synthesis of NS based on new methods of modal synthesis. Also developed is a complex NS of discrete-continuum type, which provides an opportunity in the adaptive mode to calculate stresses not only in the continuum elements, but also in the places of their greatest concentration - in the compounds. In this paper, an efficient numerical approach based on the theoretical-experimental method is proposed to maximize the minimal damping of modes in a prescribed frequency range for general viscous tuned-mass systems. Methods of decomposition and numerical synthesis are considered on the basis of the adaptive schemes. The influence of dynamic vibration absorbers and basic design elastic and damping properties is under discussion. A technique is developed to give the optimal DVA’s for the elimination of excessive vibration in sinusoidal and impact forced tall buildings system. One task of this work is to analyze parameters identification of the dynamic vibration absorber and the basic structure. The discrete-continue models of machines dynamics of some elongated element with multi mass DVA’s are offered. A technique is developed to give the optimal DVA’s for the elimination of excessive vibration in harmonic stochastic and impact loaded systems. The questions of robustness at optimization of DVA are considered. Different types of control management for semi-active DVA’s are applied. Examples of DVA’s practical implementation are presented.Item Optimization of impact dynamic vibration absorbers in the frequency band(Видавництво Львівської політехніки, 2015) Diveyev, B.; Hlobchak, M.; Martyn, V.; Yavorskyy, Y.The paper deals with the methods of calculation and optimization of constructions of the impact dynamic vibration absorbers (DVA ) for the elongated structures. An efficient numerical approach based on the theoretical-experimental method is proposed to maximize the minimal damping of modes in a prescribed frequency range for the tuned-mass impact systems. Methods of decomposition and numerical synthesis are considered on the basis of an adaptive schemes. The influence of dynamic vibration absorbers and basic design elastic and damping properties is under discussion. A technique is developed to give the optimal DVA’s for the elimination of excessive vibration in sinusoidal forced systems.