Ukrainian Journal of Mechanical Engineering and Materials Science. – 2023. – Vol. 9, No. 2

Permanent URI for this collectionhttps://ena.lpnu.ua/handle/ntb/61139

Науковий журнал

Засновник і видавець Національний університет «Львівська політехніка». Виходить двічі на рік з 2015 року.

Ukrainian Journal of Mechanical Engineering and Materials Science = Український журнал із машинобудування і матеріалознавства : науковий журнал / Lviv Politechnic National University ; editor-in-chief Oleksiy Lanets . – Lviv : Lviv Politechnic Publishing House, 2023. – Volume 9, number 2. – 94 p.

Український журнал із машинобудування і матеріалознавства

Зміст (том 9, № 2)


1
12
26
36
45
57
66
75
83
91

Content (Vol. 9, No 2)


1
12
26
36
45
57
66
75
83
91

Browse

Subject: search.filters.subject.contact pressure

Search Results

Now showing 1 - 1 of 1
  • Thumbnail Image
    Item
    Analysis of the influence of the displacement of the gear rack profile of the pair evolution gearing on the quality indicators of the transmission
    (Видавництво Львівської політехніки, 2023-02-28) Protasov, Roman; Magdolen, Ľuboš; Danko, Jan; Lanets, Olena; Vorontsov, Borys; Slovak University of Technology in Bratislava; Lviv Polytechnic National University; National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”
    The article is devoted to the study of the influence of the modification of the paired evolute gearing with convex-concave contact on the quality indicators of transmission, namely, the contact pressure and the speed of slippage in the engagement. Previous studies of evolute gears showed the presence of characteristic zones on the side surface of the tooth, which have worse values of quality indicators than in similar involute gear. One of the ways to remove these zones or to reduce their impact on the load capacity of the transmission is to modify the tooth profile, which will be implemented by shifting the profile of the processing gear rack. A displacement factor is added to the equation of the rail profile curve, which has the same value for the gear and wheel teeth, but the opposite sign. On the basis of the developed equation, the side profiles of the teeth of the gear and the wheel were constructed. Several values of the rack displacement coefficient with a positive and negative sign for the gear teeth are considered. The results of the research allow us to evaluate the influence of the amount and direction of the rail displacement on the curvature of the tooth profiles, the contact pressure in engagement along the height of the tooth, and the relative and absolute speed of sliding. Themodifications of the profile of the processing toothed rack proposed in thisworkwill expand the existence of paired evolute gears with a different set of quality indicators. This will make it possible to design gears with rational values of contact pressures and slip speeds when they are used in heavily loaded transmissions created for specific operating conditions. Gears with relatively high slip speeds can be used in road and construction equipment transmissions, which are characterized by lowshaft rotation frequency, in which the speed of slip between the teeth does not have a significant effect on the life or efficiency of the transmission. Otherwise, gears with relatively low slip speeds are very relevant when they are implemented in the transmission of modern and promising vehicles with a hybrid or fully electric power unit, especially in the case of passenger cars with high-speed electric motors.