Науковий журнал

Засновник і видавець Національний університет «Львівська політехніка». Виходить двічі на рік з 2015 року.

Ukrainian Journal of Mechanical Engineering and Materials Science = Український журнал із машинобудування і матеріалознавства : науковий журнал / Lviv Politechnic National University ; editor-in-chief Oleksiy Lanets . – Lviv : Lviv Politechnic Publishing House, 2023. – Volume 9, number 4. – 59 p.

Український журнал із машинобудування і матеріалознавства

Зміст

1. Biloborodchenko V., Biloborodchenko S. Study of the weldability of molybdenum tubular fittings of thermal converters	1
2. Dmytriv T. Dynamic model of the duration of gaseous environment pumping from a limited volume	12
3. Hrytsai I., Herus D. Study of the gear cutting process by the radial-circular method	20
4. Lavrenko I., Sushchenko M., Ishchenko O. Frequency response and strength analysis of the elbow orthosis planetary gearbox shaft using FEA	27
5. Novitskyi M., Novitskyi Y., Slipchuk A. The possibility of using structural damping in the design of a prefabricated turning cutter to reduce the amplitude of self-oscillations in the process of metal cutting	42
6. Slipchuk A., Novitskyi M. Definition of the geometric parameters of the undeformed chip at the cut-in stage when machining an external gear using the power skiving method	49
7. Contents	57

Content (Vol. 9, No 4)

1. Biloborodchenko V., Biloborodchenko S. Study of the weldability of molybdenum tubular fittings of thermal converters	1
2. Dmytriv T. Dynamic model of the duration of gaseous environment pumping from a limited volume	12
3. Hrytsai I., Herus D. Study of the gear cutting process by the radial-circular method	20
4. Lavrenko I., Sushchenko M., Ishchenko O. Frequency response and strength analysis of the elbow orthosis planetary gearbox shaft using FEA	27
5. Novitskyi M., Novitskyi Y., Slipchuk A. The possibility of using structural damping in the design of a prefabricated turning cutter to reduce the amplitude of self-oscillations in the process of metal cutting	42
6. Slipchuk A., Novitskyi M. Definition of the geometric parameters of the undeformed chip at the cut-in stage when machining an external gear using the power skiving method	49
7. Contents	57