Елементи теорії та прилади твердотілої електроніки. – 2004. – №510
Permanent URI for this collectionhttps://ena.lpnu.ua/handle/ntb/30985
У Віснику опубліковано результати науково-дослідних робіт професорсько-викладацького складу, аспірантів та докторантів електрофізичного факультету Державного університету “Львівська політехніка”, науковців та викладачів із провідних вищих закладів освіти та академічних інститутів. У Віснику публікуються роботи провідних вчених Республіки Польща. Тематика робіт пов’язана з питаннями теорії фізики напівпровідників та напівпровідникових приладів, теоретичними і практичними проблемами мікроелектроніки та сенсорної техніки. Для викладачів, наукових співробітників, аспірантів, інженерів, студентів.
Вісник Національного університету "Львівська політехніка" : [збірник наукових праць] : публікації за матеріалами 8-го міжнародного симпозіуму "Технології мікроелектроніки та мікросистеми", 14-16 жовтня 2004 року / Міністерство освіти і науки України, Національний університет "Львівська політехніка. – Львів : Видавництво Національного університету “Львівська політехніка”, 2004. – № 510 : Елементи теорії та прилади твердої електроніки / відповідальний редактор Я. С. Буджак. – 132 с. : іл.
Browse
Item Preparation and polarizing properties of the side metal pipe optical fibers(Видавництво Національного університету "Львівська політехніка", 2004) Wojcik, J.; Czyzewska, L.; Walewski, A.; Mergo, P.Technology and basic characterization of new kind of side hole optical fiber with silver layers in the holes named side metal pipe optical fiber is presented. The static deposition method of several hundred nm thickness silver layers from liquid phase was used. Polarization properties of the side metal pipe optical fibers were found.Item Emission current stabilizer to electron-impact gas ion sources(Видавництво Національного університету "Львівська політехніка", 2004) Sikora, J.; Toborek, K.; Szczepaniak, L.We describe an electron emission current stabilizer with an error amplifier dc voltage gain depending on the electron emission current. A negative feedback loop of the error amplifier contains a solid-state digital potentiometer, which is controlled by a microprocessor according to the empirically determined (based on the Ziegler - Nichols method) exponential dc voltage gain function. The obtained mean relative standard deviation of the electron emission current, for a tungsten filament operated at the pressure of/?=0.1Pa, is 36 ppm.Item Preparation and polarizing properties of the side metal pipe optical fibers(Видавництво Національного університету "Львівська політехніка", 2004) Wojcik, J.; Czyzewska, L.; Walewski, A.; Mergo, P.Technology and basic characterization of new kind of side hole optical fiber with silver layers in the holes named side metal pipe optical fiber is presented. The static deposition method of several hundred nm thickness silver layers from liquid phase was used. Polarization properties of the side metal pipe optical fibers were found.Item Concept of street light control system using the plc technology(Видавництво Національного університету "Львівська політехніка", 2004) Skoczylas, M.; Szydelko, W.The lights in the streets, roads and squares is a big budget load, so the solutions for decreasing of the costs are strongly required. The paper includes two proposition of dealing with the problem. The first is finding more efficient sources of light and the second is optimizing the usage of existing ones. The second way has been described in this work.Item Analysis of piezoresistors arrangements on the surface of circular membrane in pressure sensors(Видавництво Національного університету "Львівська політехніка", 2004) Majewski, J.A theoretical analysis concerning metrological properties of thick film piezoresistors placed on circular edge-clamped membrane is described. The change of resistance of a thick film piezoresistor, caused by the deflection of the membrane, related to the distance from the membrane centre and the width of the piezoresistor, is evaluated. Analytical expressions for different piezoresistors arrangements are presented and discussed.Item Electrical contact models based on multipoint contact(Видавництво Національного університету "Львівська політехніка", 2004) Zlonkiewicz, Z.The paper presents simulation results of contacts applied in low-current circuits. Various parameters of low-current contact space based on the model consisting of multipoint contingence were analysed. For selected model, the values of current density, power and voltage distributions at operating contact at assumed value of applied voltage were obtained. FLUX 2D software package was used to analyse the contact. This simulation aims at defining how much the number of contact points influences the distribution of current, power and voltage in contact model. The contact made of beryllium bronze with outer layer of gold was taken for the analysis. This enabled to define (electric) phenomena, which occur in operating contact, which cannot be obtained by the application on physical models.Item Practical considerations for lc differntial oscillators design(Видавництво Національного університету "Львівська політехніка", 2004) Nachev, R. G.; Ivanov, K. P.; Hristov, M. H.; Ovcharov, S. Y.; Andonova, A. S.Practical design of LC differential oscillators faces several challenges - achievement of sufficient output power, reliable start-up of the oscillator, low power consumption and etc. This paper attempts to give analytical expressions for these quantities with the aim to facilitate the design of LC differential oscillators. The paper presents derivation of the Van der Pol differential equation for LC differential oscillators. The condition for reliable start-up is formulated using the Van der Pol equation. Analytical expression for the output amplitude based on a simple oscillator model is also derived. Comparison between the analytical and simulated results is done and it shows a very good agreement.Item Optoelectronic method of estimation of chosen combustion parameters of an individual pulverised coal burner(Видавництво Національного університету "Львівська політехніка", 2004) Wojcik, W.; Golec, T.; Manak, 1.; Smolarz, 1.; Kotyra, A.; Komada, P.; Kalita, M.There are several tens of burners operating in a power boiler and their control based on averaged and delayed measurements is often not effective enough. The article describes attempts to obtain information about levels of emission of NOx and CO from the signals of the fiber-optic flame monitoring system developed in the Department of Electronics of the Lublin University of Technology. Artificial neural networks are used for estimation of emission. The article contains description of an object and the measurement system as well as results of research of nitrogen oxides and carbon monoxide modelling.Item The behaviour of insb under the irradiation with reactor neutrons(Видавництво Національного університету "Львівська політехніка", 2004) Bolshakova, I.; Brudnyi, V.; Kolin, N.; Koptsev, P.; Kost, Ya.; Kovaleva, N.; Makido, O.; Moskovets, T.; Shoorigin, F.In the paper, is investigated the influence of the irradiation with full reactor neutron spectrum up to the fluence of F=31016 cm'2 upon the electrophysical properties of complex doped InSb microcrystals and thin film InSb samples with charge carrier concentration of n=(9‘1016^3‘1018) cm'3. The influence of the initial doping level on the radiation resistance is determined. The optimal charge carrier concentration for the manufacturing of the radiation resistant magnetic field microsensors is determined and is equal to n=(6^7)‘1017 cm'3 for the complex doped InSb microcrystals, and n=3-1017 cm'3 for thin film samples.Item The current characteristics of the field emission microelements(Видавництво Національного університету "Львівська політехніка", 2004) Kozhuchar, O. T.Об’єктом математичного та фізичного моделювання були вакуумні автоелект¬ронні мікроелементи з загостреними мікроемітерами радіусів (5... 100) 10'6 м та міжелектродними відстанями (0,5...20) 10 “6 м. Діапазон напруг та струмів вибирався з умови одержання мінімальної освітленості у 50 лк на відстані 0,03 м від катодолюмінес- центного екрана. Для елементів з графітовими емітерами були одержані струми (8....600) 10 “6 А у невисокому вакуумі. Object of mathematical and phisical modeling was vacuum field emission micro elements with sharp micro emitters to radius (5... 100) 10'6 m and between electrode distances (0,5...20) 10 6 m. A range voltages and currents got out of conditions of reception of minimum light exposure 50 lux on distance 0,03 м from the screen. For elements with graphite emitters was obtained currents on (8....600) 10 A in non-high vacuum.Item Cubic boron nitride crystalline powders for dielectric and high thermal conductive thick film layers(Видавництво Національного університету "Львівська політехніка", 2004) Jakubowska, M.; Hotra, O. Z.; Shishonok, E. M.; Shipilo, V. B.; Ignatenko, O. V.; Anichenko, N. G.The authors present the results of investigating the c-BN micropowders sized in region 2-10 ^m which were synthesized in high pressure/high temperature technique by themselves. The results of investigating the properties of the powders was carried with the use of SEM microscopy, Raman spectroscopy, X-ray analysis and grain size microscopic analysis, chemical analysis. The powders were applied to prepare thick film dielectric pastes of high thermal conductivity. The pastes were screen printed onto different substrates. The properties of the layers such as microstructure, porosity, dielectric constant, resistance, thermal conductivity, etc. will be discussed.Item Adaptive controlling of power boiler(Видавництво Національного університету "Львівська політехніка", 2004) Wojcik, W.; Kalita, M.; Smolarz, A.This paper presents research on adaptive control (AC) of combastion process in in¬dustry. Results were obtained from research conducted in laboratory combustion chamber with usage of Fiber Optical Measurement System (FOMS) with electronic block. Simulation proved that implementing AC and FOMS to burning process improves flue gasses parameters -direct measure of power boiler ecologic and economical quality of work.Item The new developments in assembly technology for the sensors based on silicon structures(Видавництво Національного університету "Львівська політехніка", 2004) Szczepanski, Z.Sensor manufacturing process uses various technologies and various materials, but the sensors based on silicon structure became a dominant group of these devices. In the paper are given the last developments in assembly technique for silicon sensors. The results of our research concerning assembly technology for silicon humidity sensors and silicon gas sensors will be presented. Applied assembly processes are based on flip chip technology which plays the most important role in sensor packaging technology.Item Three levels of the electromagnetic compatibility (emc) in automotive engineering(Видавництво Національного університету "Львівська політехніка", 2004) Sperling, D.; Körber, B.; Müller, N.An important quality factor for vehicles is the compliance of the Electromagnetic Compatibility (EMC). This compliance is given both through legal requirements and by voluntary defaults of the automotive manufacturers and suppliers. In this paper, some selected EMC measuring methods will be presented, whereas two of these were recently developed at the EMC research laboratory at the University of Applied Sciences Zwickau in close cooperation with Volkswagen and Audi.Item Некоторые особенности изготовления термоэлектрических модулей пельтье повышенной надежности на основе кристаллов вьте-8е-8ь(Видавництво Національного університету "Львівська політехніка", 2004) Романюк, И. С.В работе приведено краткое описание технологических особенностей получения однородных кристаллов твердых растворов ВьТе-Бе-БЬ, электрокоммутационных слоёв меди керамических теплопереходов, а также антидиффузионных слоёв никеля ветвей ТЭМ, испытания которых показали их безотказную наработку в течение 12000 часов в непрерывном и 3000 часов - в циклическом режимах.Item Sensivity and average temperature of latgs pyroelectric detector(Видавництво Національного університету "Львівська політехніка", 2004) Proszak, W.New obtained single crystal LATGS and its selected dielectric properties are presented in this paper. Samples of the single crystal were utilised as active elements of pyroelectric detector. This paper contains also theoretical considerations for this type of detector, making possible determination of voltage-current sensitivity.Item Relation between domain structure distortion and electric permeability and spontaneous polarisation in l-lysine doped tgs single crystals(Видавництво Національного університету "Львівська політехніка", 2004) Trybus, M.; Proszak, W.Researches upon relation between domain structure and electric properties of ferroelectric TGS doped single crystals are presented in this paper. Finding such relation should make possible elaboration of simplified method of samples preselection, that should be very convenient from the point of view of its application in fabrication of active elements of pyroelectric detectors. Possibility of finding such relation includes directly from theoretical model constructed by authors.Item Зміст до Вісника "Елементи теорії та прилади твердотілої електроніки" № 510(Видавництво Національного університету "Львівська політехніка", 2004)Item Авторський покажчик(Видавництво Національного університету "Львівська політехніка", 2004)Item Титульний аркуш до Вісника "Елементи теорії та прилади твердотілої електроніки" № 510(Видавництво Національного університету "Львівська політехніка", 2004)